Rod Holder Mount 1″5/8

GS-RH (1).jpg
GS-RH.jpg
GS-RH (1).jpg
GS-RH.jpg

Rod Holder Mount 1″5/8

49.00

Simply slip into the rod holder and tighten top wing nut until the adapter is tight and immoveable. The slip design makes this a very versatile mounting for your Gullsweep®.

Quantity:
Add To Cart

Simply slip into the rod holder and tighten top wing nut until the adapter is tight and immoveable. The slip design makes this a very versatile mounting for your Gullsweep®.

Many rod holders are set at an angle to the hull to support a rod (some as much as 45°). The stainless steel support bracket for the Gullsweep® mounting pin has two side notches so you can bend it to the desired angle. Best to put mounting pin in place and then bend bracket. Make sure the Gullsweep center pin is set (or bent) so the pin will be vertical to the water.

Mount your Gullsweep® on the pin and be sure it will clear all obstacles when rotating.

To remove, loosen the screw and pull out of rod holder.

Weight: 0.500 kg

Dimensions: 30 x 8 x 8 cm